Office Mob: +8615524105871
Office Tel: +86-024-31931990
Office Fax: +86-024-22845391
Laser cutting machines are divided into metal material cutting processing and non-metal material processing:
Metal laser cutting machine is mainly used for cutting, punching and engraving of plates, including stainless steel (stainless acid-resistant steel), iron, aluminum, copper and some alloy plates. Among them, the stainless steel plate is the easiest to cut, but it is also a relatively thin stainless steel. The laser can't cut too thick stainless steel material. The maximum thickness can be cut to 4mm, and the slit can be narrowed to about 0.1mm. No damage to the material, the cut is flat and the verticality is good. For carbon steel materials, it can be cut thicker, which can reach 20mm. The laser has little thermal effect on carbon steel, so the cutting effect is very good. For high carbon steel, the quality of laser cutting and trimming is better than low carbon steel. However, its heat affected zone is large. For some alloy materials, most of them can be cut, and only a small part will have corrosion and slag. Copper is more difficult to cut with a laser, even if it is very thin.
Non-metal laser cutting machine, mainly used for fabric, leather, acrylic, wood, paper, rubber, silicone.
Non-metallic laser cutting materials are more extensive and versatile than metal laser cutting machines. It can be arbitrarily cut or engraved (commonly known as the three creation methods of engraving, engraving and plasticizing), which is large or small, and the pattern can be freely changed at will, it is very user-friendly, and it is not limited by the size of the material. The price is also relatively low and very much.
Previous: Laser cutting machine material influence